TimeZone : Watchmaking & Repair » Amateur needs help extracting broken tap tip

Goto Forum:
E-mail to friend

jack lynch

Messages: 328
Location: chicago
Registered: May 2006

buckle production

Thu, 30 June 2011 09:33

If you get serious about producing buckle blanks in mild steel, this would be an excellent application for hot forging. Not much more effort to cut the tool than it is to cut a single buckle. Hot 16 guage would punch like butter. jl

[Report message to a moderator]

Amateur needs help extracting broken tap tip - j beede - Tue, 28 June 2011 12:33 (266 clicks)

Re: Amateur needs help extracting broken tap tip - J.F. - Tue, 28 June 2011 19:00 (232 clicks)

Re: Amateur needs help extracting broken tap tip - j beede - Wed, 29 June 2011 01:38 (200 clicks)

buckle production - jack lynch - Thu, 30 June 2011 09:33 (183 clicks)

Re: buckle production - j beede - Fri, 01 July 2011 16:18 (146 clicks)

buckle production - jack lynch - Sat, 02 July 2011 16:11 (130 clicks)

Re: Amateur needs help extracting broken tap tip - jack lynch - Tue, 28 June 2011 18:19 (215 clicks)

If the hole goes through to the other side. This tool might work >>

- DON - Tue, 28 June 2011 16:20 (250 clicks)

Goto Forum:

Previous Topic: Patek servicing
Next Topic: TZ Watchmaking School--Level 1

Help | Register | Guidelines | Sponsors